Nghệ thuật xếp hình Nhật Bản: puppy pounce
Nghệ thuật xếp hình Nhật bản: puppy pounce. Tài liệu rất có ích, nó giúp bạn nâng cao kỹ năng gấp tất cả mọi thứ bằng giấy. Bạn có thể gấp thành thạo những gì bạn thích cho riêng mình và cho bạn bè bạn.
Puppy Pounce
By Perry Bailey c 1997
1 2
Valley fold and
unfolding the
diagonal both ways.
Paper white side up.
Valley fold the sides to
the center.
3
4
Valley fold the top flap
down even with the raw
edges of the previously
folded flaps.
Pull out the two side flaps.
5
6
Valley fold the sides from the Reach under to the
top to the center of the model. hidden center flap
and pull it out.
7
8
Squash fold the flap down
as if making a preliminary base.
Petal fold the top flap up
as if for the bird base.
9 10
1/2
1/2 1/2
1/2
Valley fold the top layer only
at the angle bisector, then fold
over the flap as shown to form
an irregular rabbits ear. Note,
Mark the spot half way between the long line on the bottom
the corner of the bird base and layer does not go to the tip.
the crease formed in step 2. It is formed by flattening the
paper after the two folds on
the top layer.
11 Valley fold the flap back 12
across it’s self, so that the
angle bisector you folded
in the last step is unfolded
in this step.
Swivel fold the flap
under itself so the
raw edge and the crease
meet, on the upper part.
The crease will not meet
the edge all along the lower
part.
Repeat steps 10 - 13
14 on other side.
Fold the flap up in a rabbits
ear fold. Note that when
folded up the paper under the
flap that comes to the surface 15
will be fully extended.
13
Valley fold in
half and turn
90 degrees to
the left.
Paper thickens
16 here
1/2 1/2
17
Crimp fold the front of the model back
so that the bottom of the crimp is even with Now we form the head, all it takes in order
where the paper thickens at the top, and so left to right, a crimp, a pleat an outside reverse
that it will stick up above the surface at the fold.
top
19
18
This is a cut away view of the inside of
Valley fold the legs forward, as seen in 19 the model, is if the entire front half where
Pull the snout down a little to taste. missing. At this point work a colour
change on the front legs by taking the
bottom layer of the front leg and pull
it out.
20
21
Then tuck the layer you pulled out in the
previous step and tuck it into the leg, this
will make the leg the same colour as the
body. Reverse fold the
tips of the front legs in to themselves.
Then reverse fold the top two layers
of the rear end over towards the front.
22
23
Reverse fold the hind end down.
Reverse fold the tail up.
24
25
Fold the tail down
with a crimp fold, then Crimp fold the
tuck the outside flaps in to the model. body to form the rear
end of the dog.
(Here is a hint, do it one side at a time.)
25
Mountain fold the excess paper up
inside of the model and your done!
26
To See the puppy pounce, just tap his tail!