Nghệ thuật xếp hình Nhật Bản:battle cruiser_2
Nghệ thuật xếp hình: battle cruiser_2. Tài liệu rất có ích, nó giúp bạn nâng cao kỹ năng gấp tất cả mọi thứ bằng giấy. Bạn có thể gấp thành thạo những gì bạn thích cho riêng mình và cho bạn bè bạn.
Klingon D-7 Battle Cruiser
By Perry Bailey Copyright 1997, and 2000
1. Start with bill facing up fold in half, 2. Fold the edges in to the center.
crease and unfold.
3. Fold two diagonls across the bill and a valley 4. Using the diamond formed
fold between the two x’s. by the 2 big x,s swivel fold
out the end of the bill as you
fold it over.
5.Should look like this now, 6. Fold the long flap over.
turn the model over.
7. Fold the edges into the center,while
swivel folding over a little at the big 8. Fold the long flap over again.
end of the model.
9. Fold the long flap back over using
the second layer of the bill for a
landmark.
11. Fold the entire model in half
(the model is a bit thick here).
10. Fold the sides in again as
you did in step 7. The next view
is enlarged.
1/2 1/2
12. Mark the half way point on the long flap, fold the flaps at the
back up as shown. open the long flap at the bottom the next
view is enlarged.
13. Fold up the long flap so it will
flatten at 90 degrees.
14. It should look like this. Now open the
part sticking up so it shows the inside. 15. From the side it looks
like this.
16. From the front
it will look like this.
pull the first layers
out to each side.
Note at this point
it ceases to be
flat
17. Bring out the next layer,
just like the previous layer,
except now it brings the front
back down in line with the
rest of the model.
18. Fold the corners under a bit.
19. Fold the front end down a bit.
here you can go either simple
or complicate it by making it
all match up so it is more box
like at front.
20. Finished from on top
21. Finished from the side.