logo

Nghệ thuật xếp hình Nhật Bản:gearwheel

Nghệ thuật xếp hình: gearwheel. Tài liệu rất có ích, nó giúp bạn nâng cao kỹ năng gấp tất cả mọi thứ bằng giấy. Bạn có thể gấp thành thạo những gì bạn thích cho riêng mình và cho bạn bè bạn.
Gearwheel Maarten van Gelder © 1990 Aug One gearwheel is constructed from several segments. One sheet of paper per segment. The segments are put together by slitting the last tooth of each segment in the first tooth of the next segment. By this overlap you loose teeth, but it will fix the gearwheel. Divide the paper horizontally and vertically in 8, 16, 32 or 24. The number of teeth per segment is one less than half this division: so dividing in 16 gives 7 teeth (from each segment one tooth is hidden in the next segment). ^ ^Crease line through the center of the paper 1 Colored size up. Precrease: divide the paper horizontally and vertically in 8, 16, 32 or 24. Then make vally and mountain folds as indicated. For the dotted lines you may make mountain or valley folds as you please. 2 Side view of a folded segment. The dotted lines show where the (hidden) folds are. The teeth are at the right; the left side becomes the center of the gearwheel; the (in the drawing) upper and lower side are the sides of the gearwheel. 3 In the diagram the mountain and valley folds are indicated. Two segments are coupled by slitting the upper tooth of one segment in the lower To get a nice running set of gearwheels varying in size you need to experiment wit tooth of the next segment. All folds of these two teeth should coincide. number of segments. Closing the gearwheel (the last overlap) is the most difficult action! The large wheel in this set has 6 segments, that are divided in 16 x 16. So the total amount of teeth is 6*(16/2-1) = 42. The real set I made has a motor driving the small wheel, so the total set is moving continuously.
DMCA.com Protection Status Copyright by webtailieu.net